New State-of-the Art Engineering with quality as the Only Parameter Puts the Model-600 in a Class by Itself. Featured are High Power. Low Distortion and Two Independent Power Supplies.
The Supreme Series was sold as an exclusive, 'special order only' line in most of the world (some but not all Supremes were available as parts of regular lines in Japan, Belgium and Germany), and was only available from some exclusive dealers in Canada and Califiornia. I am sure many regulars on eBay will feel bad for either missing these or letting them go for a song, as they are the absolute pinnacle of Kenwood's amplifier building knowledge, which has remained largely unsurpassed to this day - these amplifiers are the progenitors of all sought after dual-mono Kenwoods.
Features
Adoption of 3-stage differential amplifier and parallel push-pull ICL, OCL, DC amplifier which employs FET in the inital stage.
Adoption of the ASO detecting limiter and relay system for the protection circuit which protects power transistors and the speaker systems.
Two independent power supply systems installed for right and left channels.
4-stage direct-coupled all-FET equalizer with differential circuit in the initial-stage.
All-FET tone control with the turn-over switches.
Professionalized attenuator type 4-gang volume control.
tape monitoring and dubbing switches convenient for tape editing.
Making possible connections of 3-system speakers.
Presence (800 Hz, 3 kHz) control switch.
Adoption of 4-step loudness control.
Phono 1 input impedance selector switch.
Phono 2 gain control on the front panel.
Making possible connections of 2 tape deck systems.
Pre-Out Power-In terminals provided.
Output Power RMS:
2x 130 wats (8 Ohm, 20Hz - 20kHz, 0.08% THD)
2x 135 watts (8 Ohm, 1Khz)
2x 150 watts (4 Ohm, 1Khz)
Dynamic Power: 640 watts at 4 Ω
Total Harmonic Distortion:
< 0.08% (rated output into 8 Ω)
< 0,03% (1W into 8 Ω)
Intermodulation Distortion:
< 0,08% (rated output into 8 Ω)
< 0,03% (1W into 8 Ω)
S/N Ratio: 115 dB (short-circuited)
Power Bandwidth: 5 Hz - 50 kHz
Frequency Response : DC - 70 kHz (+0/-1dB)
Damping Factor: 50 at 8 Ω
Inputs Sensitivity/Impedance:
Phono 1: 2,5 mV / 30/50/100 kΩ
Phono 2: 2,5 - 5 mV / 50 kΩ
Tuner, Tape, Aux: 150mV / 50 kΩ
Max. input level :
220 mV (phono, RMS, 0.008% THD, 1Khz)
S/N ratio :
Phono: 76 dB at 5 mV input
Line; 90 dB
Outputs :
Tape Rec:
Pin: 150mV / 80 kΩ
Din: 80 mV / 150 kΩ
Frequency Response: 5Hz - 50Khz (+0/-1dB); (± 0,2dB phono)
Tone Controls:
Bass :
400 Hz : ±7,5 dB at 100 Hz
150 Hz : ±7,5 dB at 40 Hz
Treble:
3 kHz : ±7,5 dB at 10 kHz
6 kHz : ±7,5 dB at 20 kHz
Loudness (-30dB): +2 / +4 / +6 / +8 dB at 100 Hz
Low Filter: 40 Hz, 12 dB/octave
High Filter : 8 kHz, 12 dB/octave
Power Requirement: 100/117/125/200/220 or 240 V, 50/60 Hz
Power Consumption: 790 W
Dimensions (W x H x D): 440 x 154 x 388 mm
Weight: 21,3 kg
No comments:
Post a Comment