Kenwood's
KA-2002 solid state stereo amplifier highlights all the best Hi-Fi features in
compact size. Simply, yet tastefully, designed in appearance, liek all other
Kenwood products, the KA-2002 puts quality above all else. Absolutely
harmonious in the synchronized performance of all its units, the KA-2002
matches perfectly with the KT-2001 stereo tuner.
Special
Features
Compact-sized
Outside
Kenwood's
technology and experience has minimized the high-quality stereoamplifier. Its
weight is only 10,6 lbs. Its width is 13 inches only. You can handle KA-2002 as
you like and position it where you like.
Condensed
Inside
All
silicon-transistorized circuits provide enough 46 watts IHF power (at 4 ohms)
with less than 0,8% distortion and wide 20 - 30,000 Hz power bandwidth.
Precise Tone
Control
For each
bass and treble control the click type switches are used. They bring accurate
increase/decrease by 10 dB (5 steps) each at 100 Hz and 10,000 Hz. The most
suitable reproduction can be offered according to your performance or room
acoustic condition.
Balance
Control
The click
stop is equipped at the center of balance Controller so that the «0» balance
may be easily pointed out.
Push Type
Switched
Loudness,
Mode and Tape Monitor are controlled by newly developed, convenient push type
switches.
Two Input
Jacks for Phono
2 sets of
stereo record player can be connected and selected by the switch on the front
panel.
Specifications
Total Power
Output (both channel):
56 watts ±1
dB at 4 ohms
45 watts ±
dB at 8 ohms
Total
Dynamic Power (both channel, IHF):
46 watts at
4 ohms
38 watts at
8 ohms
Continuous
Power Output (each channel driven):
19/19 watts
at 4 ohms
17/17 watts
at 8 ohms
Continuous
Power Output (both channel driven):
15/15 watts
at 4 ohms
13/13 watts
at 8 ohms
Harmonic
Distortion (from 20 Hz to 20,000 Hz):
0,8% at
rated output
0,2% at -3
dB rated output
Intermodulation
Distortion:
At rated
output : Less than 0,8%
At -3 dB
rated output : less than 0,2%
Frequency
Response:
Main Input :
17 Hz to 50,000 Hz ±2 dB
High level
Input (Aux) : 20 Hz - 30,000 Hz ±2 dB
Power
Bandwidth (IHF): 20 - 30,000 hz
Input
Sensitivity (for tared output at 8 ohms load):
Phono 1 :
2,0 mV
Phono 2 :
2,0 mV
Mic : 2,5 mV
Tuner, Aux,
Tape : 150 mV
Main amp
input : 100 mV
Input
Impedance (at 1 kHz):
Phono 1 : 50
kohms
Phono 2 : 50
kohms (2,5 mV)
Aux : 50
kohms
Tape, Tuner
: 50 kohms
Recording
Output (below rated input):
Pin : 150 mV
DIN : 30 mV
Hum and
Noise (below rated output):
Phono 1, 2
: 60 dB
Tuner, Tape
: 70 dB
Aux : 70 dB
Damping
Factor (at 8 ohms): 50
Speaker
Impedance: accept 4 to 16 ohms
Loudness
Control (at -30 dB):
+8 dB at 100
Hz
+4 dB at
10,000 Hz
Bass
Control: ±10 dB at 100 Hz
Treble
Control: ±10 dB at 10,000 Hz
Switches: Mode, Tape Monitor, Loudness, Selector (Aux,
Tuner, Phono 1 and 2)
Semiconductors: 22 Transistors; 10 Diodes; 2 Thermistor
Power
Requirement: AC 110 - 120 V, 220 - 240 V, 50/60 Hz
Power
Consumption: 8 watts at no signals , 60
watts at full power
AC
Outlets: 1 switched
Dimensions
(W x H x D): 13'' x 4-5/8'' x 9-7/16''
Weight: 4,8 kg
(10,6 lbs)
No comments:
Post a Comment