JBL SE 400S

 JBL  SE-400S Energizer - this is the free-standing JBL 80 watt solid state stereo Energizer, suitable for placement anywhere. It can be enclosed in an equipment cabinet, stored out of sigh in any convenient location. Many users prefer to exhibit the award-winning design of the SE-400S as a decor accent on open surfaces. It is electronically identical to the SE-408S, and incorporates the same selection of JBL equalizer boards to perfectly complement the requirements of all JBL speaker Systems, as well as systems made by other manufacturers.

Specifications:

(All specifications are measured with both channels operating simultaneously into 8 Ω loads. AC line voltage is held to 117 volts, 60 cycles. In normal operation, the performance of the SE-400S  is not appreciably affected by line voltage fluctuations between 110 and 127 volts.)

Power Output: 

80 watts continuous RMS power;

40 watts per channel, at any frequency from 10 cps to 30,000 cps

Frequency Response:  with equalizer boards inserted for unequalized operation):

±0,25 dB form 20 cps to 20,000 cps

±1,5 dB from 3 cps to 175,000 cps

Harmonic Distortion:  less than o,15% from 20 cps to 20,000 cps at 80 watts or any level less than 80 watts

Intermodulation Distortion:  less than 0,15% at 80 watts or any level less than 80 watts (IHF standard 60 - 7,000 cps, 4 : 1 ratio)

Sensitivity:  0,8 to 3,0 volts input for rated output, depending upon the particular equalizer boards installed.

Hum and Noise:  90 dB below rated output

Transient Response:  with equalizer boards set for unequalized operation, rise time is 2,0 microseconds from 10% to 90 % of square wave signal at 160 watts peak power or any lower power level. Response to such square wave signals is free from detectable overshoot or ringing, as observed on an oscilloscope.

Overload Recovery:  less than 1/10th of one cycle to recover from 100% single cycle overload at any frequency from 20 to 20,000 cps

Output Impedance:  8 Ω rated impedance

(when driving a 16 Ω load, the SA-600 meets all published specifications except that power output is reduced to 64 watts. Wen driving a 4 Ω load the SA-600 produces 130 watts of undistorted power for brief periodes of time.  Prolonged operation at more than 40 watts per channel however will trigger the built-in automatic overload devices.

Stability:  The SE-400S, like the SA-600, utilize the exclusive JBL T-Circuit. The circuit is completely stable when connected to any loudspeaker system or even to a capactive load. Specifeid distortion and stability without ascilation are maintained through extreme variations in output load, whether resistiv, capacitive or inductive. Moreover, AC line surges do not affect the stability of the circuit.

Short Circuit Protection:  Absolute, The SA-600 cannot be damaged by accidental or intentional short or open circuit at the output terminals, or by any degree of impedance mismatch.

Transistors: 22 silicon transistors plus 20 silicon diodes.

 Dimensions (W x H x D): 15-1/4" x 4-5/8" x 7-3/4"