SYSTEM: All silicon-transistor stereo integrated amplifier
MAIN section: Direct output coupling, quasi-complementary
symmetry circuit (SEPP, OTL)
PRE section: Direct coupling equalizer amp, capacitor coupled flat
and tone control amp, combined NF type and CR type tone control.
Integrated pre and power amplifier in studio quality for discerning
hi-fi friends. The high standard and the available output power make, this
device is also suitable for professional use.
FEATURES: Differential amplifier with speaker outputs coupled
directly-without capacitors provide wide frequency response, lowest distortion,
High damping factor, large power output.
Connections for: Two turntables, tape recorder, tuner, three
Auxiliary (AUX), two speaker pairs Precise tone control through each stage a 11
deep and height controller. Separate switchable low and height filter.
Separable pre and power amplifiers and distribution to the building of
multichannel systems with output from the preamp and connection for additional
power amplifier.
Additional 5 pin DIN socket on the back.
Headphone jack and auxiliary input 3 on the front panel.
Loudness switch to aurally-volume scheme
Specifications
Main
Section: DC
quasi-complementary symmetry
Pre
Section: DC equalizer amp,
CC flat and tone control amp. Combined NF and CR type tone control
Power Output
115 watt per channel
into 4 ohm (IHF)
100 watt per channel
into 8 ohm (IHF)
70 watt per channel
into 4 ohm at 1 kHz
Continuous Power
RMS: 50 watt per channel (20 - 20,000 Hz , 8 ohm)
Power
Bandwidth: 7 Hz - 30 kHz
Total Harmonic
Distortion
20 Hz - 20 kHz,
Rated output : below 0,1%
20 Hz -20 kHz, 1
watt output : below 0,05%
IM
Distortion: below 0,1%
Main Frequency
Response: 10 Hz - 200 kHz ( +0, -2 dB)
Main
Signal-to Noise Ratio: 110
dB
Damping
Factor: 100 (8 Ω, 1 kHz)
Residual
Noise: 0,008µV
Inputs
Sensitivity/Impendance
Phono: 1,5 mV/47 kΩ
Aux,
Tuner, Tape: 130 mV/100 kΩ
Outputs
Sensitivity/Impedance
Rec
Output : 150 mV/10 kΩ
DIN
: 30 mV/82 kΩ
Pre
Out : 1 V/5 kΩ
Pre
Frequency Response: 10 Hz -
100 kHz
Pre
Signal-to-Noise Ratio:
Line : 90 dB
Phono : 70 dB
Tone
Controls : ±10 dB at 100 Hz
Loudness
: ±10 dB at 10 Hz
High Filter : 6 dB
below 100 Hz ; 6 dB abve 7 kHz
Low Filter : 8 dB at
50 Hz ; 3 dB at 10 kHz
Semiconductors: 8
FETs; 33 transistors; 36 diodes; 1 rectifier
Power
Consumption: 300 W
Dimensions
(W x H x D): 400 x 149 x 325
mm
Weight: 13,5 kg
No comments:
Post a Comment