DUAL 1010 A

Auto/Standard Turntable for single play and changer operation.

The ingenious design of the top/mounting spring screws makes it possible for you to mount and secure the Dual 1010 to its base - or to the cutout mounting board of a console -  entirely from the top. No need to fumble underneath, nor to take anything apart.

The Dual 10101 tonearm is designed for tracking at the low stylus forces required by high compliance cartridges. Once adjusted for your cartridge, the force will remain highly linear for a complete stack of records. Stsylus force is adjusted by turning the knob located at the pivot; clockwise to increase force, counterclockwise to reduce force. The range of adjustment is from 2 to 7 grams, with clock stops at 1/2 gram increments.

The tonearm has been set to descend accurately into the lead-in groove. But if the dimensions of your cartridge and/or the location of its stylus cause the lattere to touch the record either too far in or too far out, it can be adjusted quite easily.

All the operations of the Dual 1010 are activated by smoothly acting slide switches. Unlike push buttons, they do not jar the spring-mounted chassis or induce even momentary vibration. Thus the three spring-mounted footings of the Dual can enjoy a softer, more shock-absorbent characteristic, rather than a compromised stiffness.

A -                    SPEED CHANGE KNOB

B -        SPEED CHANGE LEVER ASS'Y

C -                            SWITCH SEGMENT

D -                                 SUPPORT ASS'Y

E - DRIVE WHEEL TENSION SPRING

F -                                    ROCKER ASS'Y

G -                   LEVER AND STUD ASS'Y

H -                         DRIVE WHEEL ASS'Y

I -             MOTOR PULLEY 50 or 60 Hz

J -     STATOR 110 / 150 / 220 V ASS'Y

K -                           SWITCH ARM ASS'Y

L -  MOTOR ASS'Y 110 / 150 / 220 V  

                          (LESS MOTOR PULLEY)

Specifications:

Line Voltage:  selector for 110, 150 or 220 volts

Line Frequency:  50 or 60 ha with appropriate motor pulleys

Drive:  two-pole, single-phase, induction motor

System:   Idler whell drive

Wow and Flutter: 

with 8-1/2"  turntable, max. ±0,25%;

with 11" turntable , max. ±017%

Turntable Speed:  78, 45, 33-1/3 and 16-2/3 rpm

Signal-to-Noise Ratio:  at 100 cps better than 42 dB; at 250 cps better than 50 dB

Pickup Cartridge:  tonearm will accept all crystal and ceramic cartridges with 1/2" mounting.

Standard is stereo crystal cartridge CDS 620/4/45

Dimensions (W x D):  329 x 274 mm

Weight:

With 8-1/2" turntable :  8 lbs

With 11" turntable  :  9 lbs

Power Consumption:  6,5 watts approximately