ML-2
Monophonic Power Amplifier
ML-2 Class A
power Amplifier in the appropriate system will produce striking sonic results.
Each musical instrument is more articulated, while clear and open sound is
maintained. Harshness seems to disappear from instruments with higher frequency
content, such as violins. Music takes on more body and fullness. Absolute
solidity of deep bass gives the entire performance an essential foundation and
enables the listener to hear notes and passages that were previously inaudible.
With quality recordings, the image of a performance is precise and remarkably
stable appearing to emanate from a wider, taller and deeper stage.
The ML-2 may
be operated in either the inverting or non-inverting mode. This allows a pair
to be used in bridged configuration without additional circuitry. In bridged
mode, two Ml-2s deliver twice the output voltage and four times the power. The
power supply is fully regulated under all operating conditions. The ML-2 offers
completely modular construction allowing efficient up-dating 9when available)
and ease of servicing if required.
While
outstanding performance can be achieved in high power amplifier designgs, the
refined sound quality offered by ML-2s can only be attained by a design that,
by today's standards, is limited in output voltage. The ML-2 is rated at 25
watts continuous sine wave power into 8 ohms from 20 Hz to 20 kHz with no more
than 1% THD. For this reason, Ml-2s work best with higher efficiency
loudspeakers, in multi-amp systems, or with lower efficiency speakers where
loud listening levels are not required. While Ml-2s may not be optimum for
every application, in the appropriate system they offer a beauty of musical
sound unachievable by any other design.
Specifications
ML-2:
Rated
Power: 25 watts minimum continuous
sine-wave power into 8 Ω from 20 Hz - 20 kHz with no more than 1% THD.
Input
Impedance: 100,000 Ω
Power
Supply: AC 100, 120, 220, 240 Volts,
50/60 Hz
Power
Requirement: 400 Watts nominal, 50 - 400
Hz
Connector
Complement: 2 Camac coaxial connectors;
13-pin audio connector (XLR); 5 binding posts; 1 AC receptacle/line voltage
selector
Dimensions
(overall W x H x D): 483 x 216 x 546 mm
(19" x 8,5" x 21,5")
No comments:
Post a Comment