Kenwood utilizes the
finest parts and materials and incorporates the most advanced engineering
concepts in this fine unit, to assure
you of top performance through years of constant use. From preamp yo power amp
to tumer section, the KR-5400 is a receiver you will find hard to beat.
Direct-Coupled, Pure
Complementary Symmetry Output Circuitry.
Nothing comes
between you and your music with Kenwood's direct coupled circuitry. Flat
frequency response from ultra-lows to highest highs is assured at all power
levels ip to rated output.
Large Power
Transformer - Oversize heat Sinks
Kenwood's massive
power transformer forms the heart of a dual positive-negative supply to
symmetrically power the high output transistor stages. These are mounted on
massive heat sinks for safe, cool operation even under conditions of continuous
full power output. This no-compromise design assures years of stable,
trouble-free performance.
Exclusive ASO Dual
protection
Circuit protects
both your speaker system and your receiver. Should the 'area of sale
operation" be exceeded, en instant-acting relay disengages the speakers.
Three Speaker System
Capability.
The KR-5400 lets you
enjoy stereo in as many as three separate listening areas of your home. Listen
to any one speaker system or activate two systems at once with a touch of the
front panel selector switch. A front panel headphone jack adds another listening
dimension.
An Advanced new
preamplifier
The precision
equalizer-phono preamplifier section of the KR-5400 uses low-noise metal
encapsulated transistors for the ultimate in Signal-to-Noise ratio and
reliability. With phono input sensitivity of 2,5 mV up to 330 mV (p-p) of input
signal can be accommodated at less than 0,5% Total Harmonic Distortion. Mic
input facilities on the front panel are equally noise-free and low in
distortion.
Dual tape Monitor
Circuits
The Kenwood dual
tape facilities and individual tape monitor pushbuttons allow you to monitor
two tape decks, or to dub from one deck to another while listening to program
source or recorded results.
Precise Tonal
Compensation
The bass and treble
controls of the KR-5400 employ an ingenious multi-purpose integrad circuit.
Negative feedback is used to assure no audible distortion regardless of how
much tonal compensation is required to match room acoustics, speaker
characteristics or program source deficiencies.
The IF section of
the KR-5400 is equipped with permanently aligned solid state filters for high
selectivity, superb capture ratio, and superior AM suppression. Spurious signal
rejection is more than 90 dB.
Exceptional Tuner
Performance
The tuner of the
KR-5400 is one of the most advanced available today. It achieves a sensitivity
of 1,9 µV with an unusually sharp quieting slope to assure noiseless and
distortion-free reception.
Phase-lock-Loop
Multiplex Decoder
A multi-function IC,
used in the stereo decoder section, operates on the phase-lock-loop principle
to insure uniform separation at all audio frequencies. A newlly designed LC
filter effectively reduces beat interference and intermodulation distortion normally
caused by carrier leakage.
4-channel Ready
Special, inputs and
outputs for connection of any four-channel decoder or adapter are provided on
the KR-5440. when you are ready for quadraphonic sound, there will be no need
to upset tape inputs or outputs. You retain full tape monitoring facilities for
as many as two tape decks. There's even a 4-channel detector output for future
discrete four-channel broadcasting when it's approved.
FM Tuner Section
Frequency
Range: 88 MHz - 108 MHz
Usable Sensitivity
(IHF): 1,9 µV
Quieting Slope: 5 µV (48 dB); 10 µV (60 dB); 50 µV (70 dB)
Frequency
Response: 20 Hz to 15,000 Hz +0,5 dB,
-1,5 dB
Harmonic Distortion:
Mono : 0,3% (at 400 Hz, 100% modulation)
Stereo : 0,5% (at 400 Hz, 100% modulation)
Signal-to-Noise
Ratio: 68 dB at 1 mV input
Image
Rejection: 70 dB
Selectivity (IHF ALT
channel): 65 dB
IF Rejection: 90 dB
Spurious Signal
Rejection: 90 dB
AM Suppression: 70 dB
Capture Ratio: 1,5 dB
Stereo
Separation: 35 dB at 1 kHz ; 25 dB at 10 kHz
Sub Carrier
Suppression: 60 dB
Antenna
Impedance: 300 Ω balanced; 75 Ω
unbalanced
AM Tuner Section
Usable Sensitivity
(IHF): 18 µV
Signal-to-Noise
Ratio: 45 dB at 1 mV input
Image Rjection: 60 dB
Selectivity
(IHF): 30 dB
IF Rejection: 40 dB
Antenna: Buily-in ferrite bar antenna . External
antenna terminal
Main Amplifier
Section
Continuous Power
Output RMS
Both Channel Driven:
35 + 35 watts into 8
Ω at 20 Hz to 20 kHz
37 + 37 watts into 8
Ω at 1 kHz
47 +47 watts into 4
ohms at 1 kHz (DIN)
Dynamic Power Output
(IHF):
115 watts into 8 Ω
150 watts into 4 Ω
Total Harmonic
Distortion:
0,5% at rated power
into 8 Ω
0,07% at 1/2 rated
power into 8 Ω at 1 kHz
Intermodulation
Distortion (60 Hz :7 kHz = 4:1):
0,5% at rated power
into 8 Ω
0,07% at 1/2 rated
power into 8 Ω
Power
Bandwidth: 10 Hz to 30,000 Hz
Damping Factor: 50 at 8 Ω
Frequency Response
: 10 Hz - 40 kHz
Speaker
Impednce: accept 4 Ω to 16 Ω
Preamplifier Section
Input Sensitivity
/Impedance:
Phono 1, 2 : 2,5 mV/50 k Ω
Aux : 150 mV/80 k Ω
Tape Play : 150 mV/80 k Ω
Mic : 2,5 mV/50 k Ω
Maximum Input
Voltage (RMS)
Phono 1, 2 : 120 mV (T.H.D. 0,3% at 1 kHz)
Signal-to-Noise
Ratio (IHF A Curve):
Phono 1, 2 : 70 dB
Aux : 90 dB
Tape Play : 90 dB
Mic : 65 dB
Output
Voltage/Impedance
Tape Rec (Pin)
: 150 mV/ 100 Ω
Tape rec (DIN)
: 30 mV/80 k Ω
Frequency response
Phono : RIAA Standard curve ±1 dB
Tone Controls
Bass : ±10 dB at 100 Hz
Treble : ±10 dB at 10 kHz
Loudness Control
(-30 dB) : ±8 dB at 100 Hz; ±5 dB at 10
kHz
High Filter : -10 dB at 10,000 Hz
Low Filter : - 8 dB at 100 Hz
General
Switches:
Speaker Selector
: Off, A, B, C, A + B, A + C
Input Selector: AM - FM - PHONO 1 - PHONO 2 - AUX - MIC
Mode : Left - Right - Stereo - REV - MIX
Tape Monitor : Source Mon - B Mon - A Play ; Source - B Play - A Mon
Others: Low and High Filter, Loudness, FM Muting, Mic
and Phone jack
AC Outlets: Switched 1
Power
Supply : 110 - 120 - 220 - 240 V AC, 50/60 Hz
Consumption: 340 watts at full power; 40 watts at no
signal
Dimensions (W x H x
D): 480 x 151 x 344 mm (18-15/16" x
5-15/16" x 13-9/16")
Weight: 11,5 kg (25,4 lbs)
No comments:
Post a Comment