Solid State Stereo Pre-Main Amplifier
Outstanding Features:
Silicon power transistors for the final stage obtainable highest performance and temperature characteristics.
"E.P.C." (Elactronics Protection Circuit), protecting the power transistors from damage in case of short circuit at the output terminals.
Completely O.T.L. system, distortion-free, well damped reproduction.
110 W music power
Direct reproduction from the tape head by equalizer for head.
Independent filters for high and low also tone controls for right and left respectively.
Low power consumption and instant functioning by "All transistor system".
Little heat radiation
Headphone and DIN jack
Specifications
Output Music Power:
2 x 55 W at 8 Ω load (distortion 1%, 1 kHz)
2 x 32 W at 16 Ω load (distortion 1%, 1 kHz)
Output Rated Power:
2 x 35 W at 8 Ω load (distortion 1%, 1 kHz)
2 x 23 W at 16 Ω load (distortion 1%, 1 kHz)
Frequency Response: 20 to 35,000 Hz ±1 dB aith 8 Ω load from Aux terminal
Sensitivity (for 1 kHz 8 Ω rated power output):
Tape Head : 1,5 mV (Residual Noise Below 30 mV)
Phono : 3 mV (Residual Noise Below 30 mV)
Tuner : 400 mV (Residual Noise Below 15 mV)
AUX : 400 mV (Residual Noise Below 15 mV)
Tape Monitor : (Residual Noise Below 15 mV)
Tone Control (CR Type)
Bass : 50 Hz ±14 dB
Treble : 10 kHz ±11 dB
Low Filter: -8 dB/50 Hz
High Filter: -8 dB/10 kHz
Loudness Control: +8 dB at 100 Hz, +8 dB at 10 kHz
Equalizer NF Type : RIAA for Phono NAB for Tape Head ( 50 µ sec. 19 cm/sec.)
Semiconductors: 28 Transistors; 6 Diode; 3 Thermistor
Power Requirements: AC 110 to 240 V, 50/60 Hz
Power Consumption: 17 W at full volume state
Dimensions (W x H x
D): 430 x 135 x 270 mm ( 17" x
5-3/8" x 10-5/8")
weight: 8 kg (17,6)
No comments:
Post a Comment