Pagine

Kenwood KR-8010 receiver

If you're enthusiastic about today's less efficient, super-accurate speaker systems, you know you need a very efficient, super-power receiver to drive them. And if your ears are good enough, you know the value of lots of power to handle critical musical passages with any speaker system.

That's why we created the new KR-8010. with 125 Watts per channel, minimum RMS both channels driven at 8 ohms, from 20 Hz to 20,000 Hz with no more than 0,03% Total Harmonic Distortion, you've got all the power you really need.

But more important, the KR-8010 gives you an extremely clean, low-distortion signal at the same time. For example, the Signal-to-Noise Ratio through the phono input is the best you'll find on any receiver (90 dB). Its overall frequency response is matched precisely to the RIAA curve ±0,2 dB. And the tuner delivers sensitivity and selectivity that you'll really appreciate in signal-crowded-cities.

To shape that signal into music, the KR-8010 offers a full range of front-panel control, usually found only in esoteric separates and recording studios. Like tape dubbing while listening to another source. And dual FM muting levels, Mic input and fade control. Bass, treble and midrange tone control. And more.

 

Features:

Direct-mounted power transistors permit greater heat sink efficiency for cool operation

Exceptionally low-noise phono equalizer with high overload level

4-pole dual-gate MOS FET's in RF stage and 6-element ceramic filters in IF stage for excellent sensitivity and selectivity

New PLL IC in FM Multiplex with Pilot Canceller Circuit

FM Dolby deemphasis switch and 2-level FM Muting switch

Microphone input for overdub on tape and Public Adress

2 tape deck capability with bi-directional dubbing and tape-through circuit

Triple tone controls with defeat switch

Optional CB-14K walnut veneer cabinet, B-14 walnut veneer side panels, or D-10 carrying handles available

 

Specifications

Power Output:  125 watts per channel (min. RMS both channels driven, at 8  from 20 to 20,000 Hz with no more than 0,03% Total Harmonic Distortion

Power Output

Both Channel Driven: 

130 + 130 W into 8  at 1 kHz

135 + 135 W into 4  at 1 kHz

Dynamic Power Output:  360 W into 4

Total Harmonic Distortion (20 to 20,000 kHz from Aux): 

0,03% at rated power into 8

0,02% at 1/2 rated power into 8

Intermodulation Distortion (60 Hz : 7 kHz = 4:1):  0,03% at rated power into 8

Power Bandwidth: 5 Hz to 70,000 Hz

Frequency Response:  5 Hz to 100,000 Hz -1 dB

Signal-to-Noise Ratio :  120 dB (short circuited)

Damping Factor:  35

Input Sensitivity /Impedance:  1 V/40 k

Preamplifier Section

Input Sensitivity/Impedance

Phono 1, 2 :  84 dB for 2,5 mV input; 90 dB for 5,0 mV input

Aux , Tape :  105 dB for 150 mV input

Mic :  73 dB for 2,0 mV input

Maximum Input Level:  250 mV (RMS) T.H.D. 0,03% at 1 kHz

Frequency Response:

Phono :  RIAA standard curve ±0,2 dB

Aux, Tape :  10 Hz to 100,000 Hz - 1,0 dB

Tone Control

Bass :  ±12 dB at 50 Hz

Mid :  ±12 dB at 800 Hz

Treble :  ±12 at 15 kHz

Loudness Control (Vol -30 dB):  +10 dB at 100 Hz

Subsonic Filter:  18 Hz 6 dB/oct

Output Level/Impedance

Tape Rec (Pin) :  150 mV/300

Tape Rec (DIN) :  30 mV/80 k

Pre Out :  1,9 V/1 k

FM Tuner Section

Usable Sensitivity:  9,8 dBf (1,7 µV)

50 dB Quieting Sensitivity

Mono :  14,1 dBf (2,8 µV)

Stereo :  36,3 dBf (30 µV)

Signal-to-Noise Ratio at 65 dBf

Mono :  80 dB

Stereo :  72 dB

(75 dB at 10 mV)

Total Harmonic Distortion

Mono :  0,1%

Stereo :  0,15%

Frequency Response:  20 Hz to 15,000 Hz +0,2 -2.0 dB

30 Hz to 15,000 Hz +0,2 -0,5 dB

Capture Ratio:  1,0 dB

Image Rejection Ratio:  85 dB

Spurious Response ratio:  105 dB

IF Response ratio:  90 dB

Alternate Channel Selectivity:  85 dB

AM Suppression Ratio:  60 dB

Stereo Separation Ratio:  45 dB at 1,000 Hz (30 dB at 50 Hz - 15,000 Hz)

Subcarrier Product Ratio:  67 dB

Antenna Impedance:  300  balanced; 75  unbalanced

FM Frequency Range:   88 MHz to 108 MHz

AM Tuner Section

Usable Sensitivity:  10 µV (250 µV/m)

Signal-to-Noise Ratio:  50 dB

Image Rejection:  50 dB

Selectivity:  35 dB

General

AC Outlet:  1 Switched, 1 Unswitched

Power Consumption:  850 W at full power

Dimensions (W x H x D):  534 x 167 x 459 mm (21-⅓2" x 6-19/32" x 18-1/16")

Weight:  18,3 kg (40,3 lbs)


 

No comments:

Post a Comment