The Teac
Model AS-200 Integrated Amplifier combines a 100 watt (at 4 ohms) total power
output with centralized stereo system control. A differential-type integrated
amplifier with high-cut and low-cut filters provides a wide dynamic range with
natural-sound reproduction. Switched power outlets, complete facilities for
stereo system interconnection, and hidden panel controls permit elaborate
system setup with centralized control from this stylish amplifier.
Features:
Differential-type
integrated amplifier: providing a wide
dynamic range, stability, and high-quality performance.
Transistorized
amplifier: with high sensitivity FET
input circuit and three-stage direct coupled amplifiers.
Bass and
treble controls: for tone compensation
with tone cancel switch.
Preamp
center-channel output: for
three-dimensional stereo effects.
Switched and
unswitched AC outlets: for central
stereo system power source control.
Large
variety of input connectors: on rear
panel for versatile application with RIAA equalization for phono inputs.
Overload
protection: by push-to-reset circuit
breakers.
Attractive
front panel: with only essential
controls showing; infrequently used controls are hidden behind lower front
panel.
Specifications:
Continuous
Power Output: 50 W / 50 W at 4 Ω
Power
Bandwidth: 30 to 30,000 Hz
Frequency
Response: 20 to 80,000 Hz
High
Frequency Distortion: less than 0,5%
IM
Distortion: less than 0,5%
Signal-to-Noise
Ratio:
Phono : less
than 65 dB
High Level
: less than 75 dB
Controls:
Low
Tone : ±10 dB variation at 100 Hz
High Tone :
±10 dB variation at 10,000 Hz
Output :
Pre-amplifier
: 1 volt
Tape
Recording : 0,2 volt
Center
Channel : 1,4 volt
Input: Tuner; Aux 1 and 2; Phono 1 and 2; Tape Deck
1 and 2
Hidden Panel
Controls:
Switches: Phono,High-cut filter, Low-cut filter; tone
and loudness
Selector
Switches: Mode (Reverse, Stereo, Lift,
Right and L+R), Speaker (off, Main, remote, and M+R)
Controls: Bass and Treble, Headphone jack
No comments:
Post a Comment