Auto/Standard
Turntable for single play and changer operation.
The
ingenious design of the top/mounting spring screws makes it possible for you to
mount and secure the Dual 1010 to its base - or to the cutout mounting board of
a console - entirely from the top. No
need to fumble underneath, nor to take anything apart.
The Dual
10101 tonearm is designed for tracking at the low stylus forces required by
high compliance cartridges. Once adjusted for your cartridge, the force will
remain highly linear for a complete stack of records. Stsylus force is adjusted
by turning the knob located at the pivot; clockwise to increase force,
counterclockwise to reduce force. The range of adjustment is from 2 to 7 grams,
with clock stops at 1/2 gram increments.
The tonearm
has been set to descend accurately into the lead-in groove. But if the
dimensions of your cartridge and/or the location of its stylus cause the
lattere to touch the record either too far in or too far out, it can be
adjusted quite easily.
All the
operations of the Dual 1010 are activated by smoothly acting slide switches.
Unlike push buttons, they do not jar the spring-mounted chassis or induce even
momentary vibration. Thus the three spring-mounted footings of the Dual can
enjoy a softer, more shock-absorbent characteristic, rather than a compromised
stiffness.
A - SPEED
CHANGE KNOB
B - SPEED
CHANGE LEVER ASS'Y
C - SWITCH
SEGMENT
D - SUPPORT
ASS'Y
E - DRIVE
WHEEL TENSION SPRING
F - ROCKER
ASS'Y
G - LEVER
AND STUD ASS'Y
H - DRIVE
WHEEL ASS'Y
I - MOTOR
PULLEY 50 or 60 Hz
J - STATOR
110 / 150 / 220 V ASS'Y
K - SWITCH
ARM ASS'Y
L - MOTOR
ASS'Y 110 / 150 / 220 V
(LESS MOTOR PULLEY)
Specifications:
Line
Voltage: selector for 110, 150 or 220
volts
Line
Frequency: 50 or 60 ha with appropriate
motor pulleys
Drive: two-pole, single-phase, induction motor
System: Idler whell drive
Wow and
Flutter:
with
8-1/2" turntable, max. ±0,25%;
with
11" turntable , max. ±017%
Turntable
Speed: 78, 45, 33-1/3 and 16-2/3 rpm
Signal-to-Noise
Ratio: at 100 cps better than 42 dB; at
250 cps better than 50 dB
Pickup
Cartridge: tonearm will accept all
crystal and ceramic cartridges with 1/2" mounting.
Standard is
stereo crystal cartridge CDS 620/4/45
Dimensions
(W x D): 329 x 274 mm
Weight:
With
8-1/2" turntable : 8 lbs
With
11" turntable : 9 lbs
Power
Consumption: 6,5 watts approximately
No comments:
Post a Comment