Stereo
Pre-amplifier - Control Unit
Features:
RIAA
deviation of ±0,2 dB (20 Hz - 20 kHz) and phono Signal-to-Noise of 87 dB
Low-noise
transistors, used in the first stage, are combined with high gain ICs to reduce
noise and improve stability. Carefully selected polypropylene capacitors and
high-precision metal-film resistors are used as the RIAA elements for an RIAA
deviation of less than ±0,2 dB over a frequency range of 20 Hz to 20 kHz,
thereby yielding an extremely accurate frequency response. The maximum rated
input of 200 mV (at 1 kHz) assures an ample margin for the input signals.
Two power
supplied (plus and minus) with high-performance differential amplifier ICs.
A plus-minus
dual power supply design is used for the high-performance differential
amplifier ICs in the amplifier circuit. This allows a faithful amplification of
the signals with a minimum of distortion.
A
high-performance tone control circuit that is bypassed when the knobs are set
at the center "0" position.
A low-cut
filter suppresses noise components in the ultra-low-frequency range such as
those generaated by a warped record.
With just a
flick of the muting switch, the power output can be reduced to one-tenth of the
set level.
The loudness
switch enhances the low-frequencies when listening at low volumes.
Specifications
Signal-to-Noise
Ratio (IHF A curve short circuited):
Phono : 87 dB
Tuner : 98 dB
Aux : 98 dB
Tape : 98 dB
RIAA
Deviation : ±0,2 dB )20 Hz to 20 kHz)
Inputs
Sensitivity/Impedance
Phono : 2,5 mV (200 mV max. input)
Tuner, Aux
1, Aux 2 : 150 mV/47 k Ω
Tape
Monitor:
Play : 150 mV/47 k Ω
Rec : 150 mV/47 k Ω
Output
Level/Impedance: 0,8V/47 k Ω
Tone
Controls
Bass : ±8
dB at 100 Hz (600 Hz)
Treble : ±8
dB at 10 kHz (3,5 kHz)
Low
Filter: 30 Hz/6 dB/octave
Muting: -20 dB
Loudness
: +7 dB at 100 Hz ; +3,5 dB at 10 kHz
(with -40 dB)
Semiconductors: 2 ICs; 10 Transistors; 10 Diodes; 5 LEDs
Power
Requirements: 220 V, 50/60 Hz
Power
Consumption: 5 W
Dimensiond
(W x H x D): 250 x 71 x 229,5 mm
