Leak Delta Turntable

It is important that the turntable in your high-fidelity system should be specifically designed to complement in performance and appearance the other components in your system. To this end we worked with one of Switzerland's foremost turntable specialists to create the Leak Turntable.

It is a dynamically balanced turntable which weighs over half a stone, eliminating the distortions that occur in lighter turntables due to internal vibrations.

The chromium plated pick-up arm is so sensitive that it can be affected by the infinitesimally centrifugal force it creates as it moves towards the centre of the record. We compensate for this with a bias compensator utilising a minute counterbalance supported on nylon thread. The turntable also has a viscously damped pick-up cueing device. In spite of this precision the Leak turntable is, like all the finest machines, simple to operate and maintain. The speed of the turntable is infinitely variable between 30 rpm and 86 rpm.

The very silent 4-pole motor is spring mounted onto a rigid steel baseplate. The power is transmitted from the conical motor shaft to the turntable by a ruber covered idler wheel. The speed is changed by moving the idler wheel on the motor shaft.

 

Specifications:

System:  Idler drive

Turntabel Type:  Dynamically balanced turntable. Viscously damped pick-up lowering device. Speed adjustment infinitely variable between 30 and 86 rpm.

Wow and Flutter:  0,06%, according to DIN Specifications

Rumble:  -60 dB, measured in according to DIN Specifications

Speed variations:  for a 10% change in mains voltage ±0,2%.

Maximum Speed Variation:  0,3%,  when loaded by a pick-up playimg at 6 grams

Motor:  4-pole constant valocity motor with conical rotor spindle

Pick-up Arm:  Arm with counter balanced weight.

Bearings:  Knife-edge bearings

Stylus Pressure:  adjustable from 0,5 to 5 grams with calibrated sliding weight

Minimum Stylus Pressure:  0,5 grams

Headshell:  Removable lightweight pick-up headsell

Cartrdige:  Shure magnetic M75B type 2

Stylus Overhang:  17 mm (0,675")

Stylus Position Adjustment:  13 mm (0,5")

Offset Angle:  23° 12'

Tracking Error:  ±0,8

Platter:  Die-cast zinc

Truntable Platter Weight:  4 kg (8,8 lb)

Power Requirements:  AC mains 200 - 240 V, 50 Hz

Power Consumption:  14 VA

Dimensions (W x H x D):  400 x 166 x 371 mm (16" x 6,6" x 14,8")

Weight:  8,5 kg (18,7 lbs)

Finish:  Teak