DC Stereo
Power Amplifier SA-P30
Features:
Toroidal
power transformer for compact size and high output power
The large
capicty power supply is composed of a toroidal transformer with particularly
high efficiency and two 10,000 µF large-sized design capacitors. This exhibits
ample margin, and more than enough power is supplied for an effective output of
35 W + 35 W. this enables dynamic, high quality sound reproduction.
A wide-range
DC Amplifier that reproduces the original sound with faithfully
With this DC
Amplifier, no condensers are used within the load return loop since condensers
can cause a phase distortion
The system
can be upgraded to a 70 W monaural amplifier with just a flick of a switch.
A switch
makes a BTL connection turning this 35 W + 35 W stereo amplifier into a 70 W
monaural amplifier. If one more of this unit is added on in the future, the
system can be upgraded into a 70 W + 70 W power amplifier
Protection
Circuits
The
protection circuit employs a newly developed IC and a relay eliminates
"pop" noise produced when the power is switched on and off. Other
features protect the transistors from short-circcuits in the output and also
the speakers which are isolated when leakage of DC is detected in the output.
LED bar
graph display to indicate the output level.
Specifications
Power
Output: 35 W + 35 W with 4 Ω impedance
(0,5% distortion, 20 Hz to 20 kHz)
Distortion: 0,02% (1 kHz)
Input
Sensitivity/Impedance: 560 mV/47 k Ω
Signal-to-Noise
Ratio: 112 dB
Damping
Factor: more than 30 (8 Ω, 1 kHz)
Circuit
System: DC amp
Semiconductors: 4 ICs; 10 Taransitors; 2 FETs; 25 Diodes; 6
LEDs
Power
Requirements: 220 V, 50/60 Hz
Power
Consumption: 240 W
Dimensions
(W x H x D): 250 x 71 x 218 mm
No comments:
Post a Comment