The
performance specifications of Yamaha's CR-1000 professional-class stereo
receiver are distinguished i two ways; they are superb and, like all Yamaha
stereo specifications, they are conservatively rated and guaranteed. This of
course says a great deal about the kind of quality the audiophile should expect
from this receiver; but it says even more about the company that would build
it. By any standards, the CR-1000 is an important achievement. It is a
combination of an outstanding FM tuner and an extremely low-distortion,
high-power, versatile amplifier, both of which could stand by themselves as
independent hi-fi components. (It does not include an AM tuner because the
discriminating music lover would most likely prefer to be without it.) the unit
features the world's first application of negative feedback to the FM tuner's
multiplex switching circuit, resulting in very low harmonic distortion and
intermodulation distortion. Power is prodigious; RMS continuous output of 70
watts per channel into 8 ohms, both channels driven, at 0,1% THD over 20 Hz to
20 kHz. Because the FM tuner uses an elaborate 5-gang tuning capacitor, as well
as a triple tuning circuit with dual-gated MOS-FET's, the quality of FM
reception is at the highest level presently possible for a tuner of any cost.
Which leads us to another significant facet of the CR-1000. with all its
excellence, you shall discover its price to be surprisingly agreeable. This, by
itself, makes the CR-1000 a most unique stereo proposition.
FM Tuner
Section Features:
Super-Sensitive
FM Front End with Dual-gated MOS-FET's and Frequency-Linear 5-Gang Tuning
Capacitor.
IC IF
Amplifier with 7-stage Differential Amplifier and Six Ceramic Filters
A Yamaha
Exclusive - Multiplex Demodulator with Negative Feedback-Applied Transistor
Switching Circuit.
Yamaha-Exclusive
Auto-Touch Tuning
Wide-Dynamic-Range
Signal Strength Meter and Precise Center Meter.
Permanent
Light-emitting Diode Indicators for Power, FM Stereo and AFC/Station.
Thump-free
Switched, Double FM Muting with Muting Level Control.
Wide,
Precise, Ultra-Smooth Tuning Dial.
300-Ω and 75-Ω Antenna Terminals
Preamplifier
Section Features:
Direct-Coupled
Phono Equalizer.three-Stage Direct-Coupled, Low-Noise, Low-Distortion Tone
Control and Filter Amplifiers.
Continuous
Loudness Control
Specialized
Microphone Amplifier for Mic Mixing.
Two Tape
Record/Monitor Circuits with Dubbing.
Power
Amplifier Features:
Direct-Coupled
OCL Pure Complementary Power Amplifier
Two 10,000
Micro-Farad Power Supply Capacitors for High Power
Built-in
Protection for Power Transistors and Speakers
Other
Features:
Separable
Preamplifier and Power Amplifier
Connects Two
Pairs of Speaker Systems
Logical
Front-Panel Control Arrangement; All Switches and Controls Have a Smooth, Firm,
Professional Feel and are Arranged for Ease of Operation.
Two
Phono Input Circuits, with Input Impedance Selector (100, 50 or 30 K Ω) for One
Four
Convenient AC Outlets, Two Controlled by the Receiver's Power Switch
Two Large
Grounding Terminals
Headphone
Jack
Foolproof
One-Touch Speaker Terminals
IF Output
for 4-channel Capability
Multipath
Output for Improved Antenna Setting.
Specifications
Audio
Section
Power Output
Dynamic
Power (IHF): 200 watts at 4 Ω; 200 watts at 8 Ω
Continuous
RMS Power (each channel driven):
100/100
watts at 1,000 Hz (4 Ω)
80/80
watts at 1,000 Hz (8 Ω)
Continuous
RMS Power (both channel driven):
100/100
watts at 1,000 Hz (4 Ω)
75/75
watts at 1,000 Hz (8 Ω)
Total
Harmonic Distortion
Power
Amplifier Only: less than 0,1% at rated
power (0,04% at 1 watt)
Preamplifier
Only :
Phono to
Pre-Out: less than 0,1% at rated power
Aux to
Pre-Out : less than 0,02% at rated power
Overall (Aux
to Power Output): less than 0,1% at
rated power
Intermodulation
Distortion (70 Hz : 7,000 Hz = 4:1 SMPTE method):
Power
Amplifier Only (8 Ω): less than 0,1% at rated power (0,05% at 1
watt)
Overall
(Aux to Power Output): less than 0,1% (8
Ω) at rated output
Power
Bandwidth (IHF): 5 to 50,000 Hz
(distortion 0,5% const.)
Frequency
Response (at 1 watt):
Overall
(Aux,Tape Pb to Power Output): 10 to
50,000 Hz +0,5 dB -1,0 dB
Overall (Mic
to Power Output): 100 to 10,000 Hz +0,5
dB -6 dB
Power
Amplifier Only: 10 to 100,00 Hz +0 dB -1
dB
Deviation
from RIAA : 30 to 15,000 Hz ±0,2 dB
Load
Impedance: 4 to 16 Ω
Damping
Factor: 70 at 1,000 Hz
Channel
Separation (at rateed power. 1 kHz)
Power
Amplifier Only : 60 dB
Overall from
Phono 1, 2 : 50 dB
Overall from
Aux, Tape Pb : 50 dB
Overall from
Mic : 50 dB
Hum and
Noise (IHF, Closed Circuit A Network):
Overall from
Phono 1, 2 : better than 80 dB
Overall from
Mic : better than 70 dB
Overall from
Aux, Tape Pb : better than 90 dB
Power
Amplifier Only : better than 100 dB
Volume at
Minimum : better than 90 dB
Input
Sensitivity / Impedance (at rated power, 1 kHz):
Phono
1 : 3 mV / 30 k Ω, 50 k Ω, 100 k Ω
Phono
2 : 3 mV / 50 k Ω
Phono 1, 2
Max. Input Capability: 280 mV (THD 0,1%)
Mic
: 3 mV / 50 k Ω
Mic Max.
Input Capability: 450 mV (THD 0,3%)
Aux 1,
2 : 150 mV / 40 k Ω
Tape
Pb A, B : 150 mV / 40 k Ω
Power
Amplifier Input: 775 mV / 40 k Ω
Output Level
/ Impedance (at rated Power, 1 kHz)
Tape
Rec Out A, B : 150 mV ? 2 k Ω
Pre
Out : 775 mV / 2 k Ω ; 3,000 mV (Max output THD 0,1%)
Tone
Controls
Bass : ±15 dB at 50 Hz
Treble
: ±10 dB at 10 kHz
Filters
Low : -3 dB at 20 Hz , 70 Hz, (12 dB/oct)
High : -3 dB at 6 kHz, 12 kHz (6 dB/oct)
Loudness
Control (Volume at Minimum): +10 dB at
100 Hz; +5 dB at 10,000 Hz
FM Tuner
Section
Tuning
Range: 88 - 108 MHz
Sensitivity
(Mono):
IHF : 1,7 µV
DIN (40 kHz
Dev, S/N 26 dB) : 1,1 µV
Sensitivity
(Stereo):
DIN (40 kHz
Dev, S/N 46 dB) : 40 µV
Quieting
Slope: 55 dB at 5 µV; 60 dB at 10 µV
Limiting
Level (-3 dB): 1,1 µV
Image
Frequency Rejection: 110 dB
IF
Rejection: 110 dB
Spurious
Response Rejection: 110 dB
AM
Rejecton: 55 dB
Capture
Ratio: 1 dB
Selectivity: 80 dB (IHF); 65 dB (DIN, 40 kHz Dev, ±300
kHz)
Signal-to-Noise
Ratio (Mono):
IHF (75 kHz
Dev) : 75 dB
DIN (40 kHz
Dev) : 69 dB
Signal-to-Noise
Ratio (Stereo):
IHF (75 kHz
Dev) : 72 dB
DIN (40 kHz
Dev) : 66 dB
Total
Harmonic Distortion (Antenna Level; 1mV)
MONO
IHF (400 Hz;
75 kHz Dev) : 0,15%
DIN (1 kHz;
40 kHz Dev) : 0,15%
50 - 10,000
Hz
IHF (75 kHz
Dev) : 0,30%
DIN (40 kHz
Dev) : 0,30%
STEREO
IHF (400 Hz;
75 kHz Dev) : 0,30%
DIN (1 kHz;
40 kHz Dev) : 0,30%
50 - 10,000
Hz
IHF (75 kHz
Dev) : 1,0%
DIN (40 kHz
Dev) : 1,0%
Stereo
Separation:
IHF (400 Hz;
75 kHz Dev) : 45 dB
DIN (1 kHz;
40 kHz Dev) : 45 dB
50 - 10,000
Hz
IHF (75 kHz
Dev) : 35 dB
DIN (40 kHz
Dev) : 35 dB
Frequency
Response:
50 - 10,000
Hz : ±0,5 dB
20 - 15,000
Hz : ±1,5 dB
Sub-Carrier
Supression: 60 dB
Muting
Override Signal Level: 10 - 50 µV
Stereo
Level: 10 - 50 µV
Antenna
Impedance: 300 Ω (balanced), 75 Ω
(unbalanced)
IF Out
Level and Impedance: 400 mV / 1 k Ω
General
Semiconductors: 2 Ics, 2 MOS FET's, 98 Transistors, 10 FET's,
3LD's, 56 Diodes, 5 Zener Diodes
Power
Source: Ac 117 V 50/60 Hz
Power
Consumption: 430 watts (Max), 250 watts
(rated)
AC
Outlets: 2 Switched (total 200 watts), 2
Unswitched (total 200 watts)
Dimensions
(W x H x D): 510 x 174 x 335 mm
(20" x 6 ¾" x 13 ¼")
Weight: 19 kg (41,8 lbs)
Nessun commento:
Posta un commento